large size can be filled with more powder. It also can change to any color and Surface Treatment, like rubber, UV spray, plating. the parts of plastic injection will be assembled together in our assembly workshop. Its size is 119.6*63MM, and surface treatment is electronic plating. There are some different colors for bottom and top cover. The molds are existed, so we can produced for client at anytime. And it is good for us to control the quality and timing.
Silk Screen Printing,Rectangle Compact Packaging,Compact Assembly,Plastic Injection For Compact Package DongGuan LongTen package Products Co. Ltd , http://www.longtenpack.com
Safety valve adjustment and verification methods
1, safety valve should be carried out before the installation of pressure test and air tightness test to test the safety valve strength and sealing performance. Qualified before correction and adjustment. 2, in the gas test stand, by adjusting the load on the valve to correct the safety valve opening pressure. Lever-type safety valve to adjust the hammer position, spring-loaded safety valve to adjust the amount of spring compression. Safety valve opening pressure should be consistent with the boiler, pressure vessel safety technology supervision regulations of the relevant provisions. 3, in the container, by adjusting the safety valve adjustment ring and the valve clearance, to adjust the relief valve discharge pressure and back seat pressure. If the safety valve in the opening pressure only leaks and does not take-off or jump though the pressure drop after a violent vibration and "beep" sound, the gap is too large, should be adjusted to be smaller. If the back seat pressure is too low, the adjustment ring gap is too small, should be properly adjusted. Steam relief valve discharge pressure should be less than or equal to 1.03 times the opening pressure, opening and closing pressure difference should not exceed 10% of the opening pressure. Air or other gas relief valve discharge pressure should be less than or equal to 1.10 times the opening pressure, opening and closing pressure difference is not greater than 15% of the opening pressure. 4, safety valve calibration and pressure adjustment, the unit must be in charge of boiler pressure vessel safety technical staff presence, adjustment and calibration device with a pressure gauge accuracy of not less than 1, online calibration should be Safety precautions. 5, the calibration process, calibration staff should make a timely record. Check the qualified safety valve, the installation of the accessories should be mounted on the lead seal to prevent the well-adjusted to change the state.