I. Principle of Bulk Cement Truck for Powder Material Trucks: The power of the chassis of the vehicle is transmitted to the air compressor through the power take-off and the transmission shaft. The air compressor fills the air in the tank so that the air and powder materials in the tank are fully mixed to form a fluid state. When the pressure reaches a certain amount, the discharge butterfly valve is opened and the material is discharged. Second, the bulk cement trucks bulk cement truck user manual: Broad Bean Peeling Machine,Fava Bean Peeling Machine,Fava Bean Skin Peeler,Fava Bean Skin Peeling Machine Yantai Maoyuan Food Machinery Manufacturing Co.,Ltd , https://www.peanutmachinery.com
1. When driving bulk cement trucks, do not overspeed or overpressure. Overspeed or overpressure can seriously damage the air compressor. The maximum speed of this machine can be seen in the main technical data sheet, working pressure is 0.2MPa.
2, do not change the direction of rotation of the air compressor, otherwise, the oil pump will not seriously damage the machine.
3, Do not quickly start or stop the air compressor, but should slowly increase or deceleration, otherwise, punch pressure will damage the air compressor.
4. Do not stop the air compressor before decompression. Otherwise, the powdered material may flow back into the air cylinder, causing serious damage to the air compressor.
5. Before starting the machine, check the oil level. The oil level must not be lower than the lower limit of the oil level. Always check whether the oil pump is supplied with oil. If oil is not supplied, check the machine immediately for shutdown. Otherwise, the lack of oil can seriously damage the air compressor.
6. The lubricating oil used in this machine is CD40 diesel engine oil. It is forbidden to mix different brands of lubricating oil. Otherwise, the deterioration of lubricating oil will affect the lubricating effect.
7, to replace the oil on schedule, the new machine after 30 hours of use, the crankcase out of the oil, clean the crankcase and oil filter net, and then change the oil. After that, change the oil once a year. 7, to check and clean the oil filter. Normal conditions are checked and cleaned once every quarter. If the machine usage rate is high, it should be checked and cleaned once a month.
8. The air filter should be maintained and cleaned every 30 hours of operation. At the same time when the filter element is rotated, the compressed air with the pressure less than 0.6 MPa is blown from the inside to the outside. After servicing five times, please replace the new filter element. Never clean the filter element with oil or water.