No matter at office or at home, you'll need the rubbish can to keep the space clean. On this website, you will find there's a wide range of options for you to choose the trash can. However, choosing a trash can is not as simple as it sounds. You may need different waste bins in different places. For example, you may need the dust bin with lids for the kitchens so that you will not smell anything bad and you may go for the open garbage bin for dry trash at home or at office. Would you please explore our store to find the perfect trash can for your space?
rubbish bin,metal trash can,steel waste recycling bin,pedal rubbish bin Huiye Hardware & Electrical Equipment Company Ltd. , https://www.hardwarehuiye.com
In China's machine tool industry, the size of machine tools is different, and the number of production is different. For medium and small-sized machine tools, mass production is generally used: large and heavy machine tools are produced in single or small batches. General machine tool parts conditions such as load, impact and lubrication conditions are significantly better than cars, tractors and heavy machinery.
The part is the support of the whole machine tool, and its accuracy maintainability is very high. Therefore, this article focuses on the characteristics of the heat treatment of the machine tool parts, roughly boils down to the following points:
(1) The use of steel for general use of non-alloy (carbon) structural steel and alloy structural steel. A few parts, such as inlaid steel rails, hardened screws, etc., use low-alloy tool steel and bearing steel.
(2) Partially hardened and surface hardened parts There are many machine tool parts that only require high wear resistance on the part of the surface, except for a few parts that are partially hardened by a salt bath furnace, most of the parts use local surface quenching methods (eg, Induction heating, laser heating, ultrasonic heating, etc.) Hardening.
(3) Salt bath furnaces are used for the non-oxidizing heating of most parts of the cycle-type furnace. Vacuum furnace or kerosene drip in a gas carburizing furnace to create a protective atmosphere.
(4) Precise parts require high dimensional stability Usually, one or more stabilization treatments are often arranged in the process, such as stress relief annealing, low-temperature aging treatment, and cold treatment, to minimize the residual internal stress and ensure high dimensional stability. Sex.
(5) Most steel parts must undergo pre-heat treatment such as steel castings, forgings, and rolled materials. They must be pre-treated by annealing, normalizing, or tempering to increase their strength, eliminate defects in the structure, and improve processing performance. : At the same time, prepare the organization for the final heat treatment to reduce heat treatment distortion.
(6) Widely used low-temperature chemical heat treatment machine tool parts are mostly designed from the perspective of rigid, heat treatment requirements become smaller, high wear resistance and good dimensional stability. Therefore, nitriding, nitrocarburizing and other low-temperature chemical heat treatment process has been widely used.
Interpretation of the Six Characteristics of Heat Treatment of Metal Cutting Machine Parts
Metal cutting machine A machine that uses a cutting method to machine metal blanks into machine parts. It is a machine that builds machines. We customarily call them machine tools.