Running-in and use of non-actuated generator set diesel engine

1. Warm-up of the diesel generator sets The diesel generator sets are warmed up from no-load speeds of 700r/min to 1000 to 1200r/min. When the outlet water temperature reaches 55°C and the oil temperature reaches 45°C Only allow full-load operation.
2. Running-in of diesel generator sets New diesel generator sets or overhauled diesel engines must be run-in before starting use. After the parts have been machined, there will always be different degrees of tool marks on the surface. If a certain amount of wear is performed immediately without a certain running-in, the parts and components will be seriously worn, which will affect the service life or failure of the diesel generator set. Until damaged.
3. The power output of the diesel generator set
WD series diesel generator sets output power from the flywheel end. When using it, it is forbidden to directly install the belt pulley at the flywheel end and drag the machine tool laterally, because the output power can easily cause the crankshaft and the main bearing to directly bear the lateral force and damage, when the coupling is used. When the implement is connected to the implement, the centerline of the implement and the centerline of the crankshaft should be on the same axis. If a flexible coupling is used, its coaxiality is not greater than 0.30 mm; if a rigid coupling is used, its coaxiality should not be greater than 0 0.10 mm.
The crankshaft front end of the diesel engine can output part of the power, and its rated output power is not more than 50 kW, but at this time, driveshaft bearings, clutches, etc. should be installed between the front axle and the driven equipment. If it is a direct drag, it must not exceed llkW so as not to damage the front axle, main bearing and transmission gear of the diesel engine. For models with fans, it is never allowed to drive the machine directly by dragging it directly.
The user must take care that the diesel generator set is not allowed to start with a load. Therefore, a clutch device should be provided between the diesel generator set and the load that cannot be operated with no load, and the diesel engine should be started with the clutch disengaged.