It is a machine that sits on a table or bench, and has an opening through which you feed insulated wire.
Instruction:
press the setting screw tightly, adjust the knifepoint in the right place, try peeling the cable again until you reach the ideal result, then tighten the screw bolt.
the largest channel and the knifes are still cutting deeply into the metal) adjust the lower mandrel setting screw (which will raise the upper
cutters/rollers), put the knife axes up tightly to the desired place (make sure that both the left and right sides rise or fall at the same time
in order to keep the knife and main axes level).
Cable Wire Peeling Machine Cable Wire Peeling Machine, Cable Peeling Machine, Wire Peeling Machine, Cable Peeling Tool,PVC Insulated Cable Peeler TAIZHOU GUANGLONG WIRE STRIPPING MACHINE MANUFACTURING CO.,LTD , https://www.scrap-wire-stripper.com
2. When the upper and lower adjacent middle sections are simultaneously harvested, the inclined length of the upper middle section mining working surface should be more than 20m ahead of the lower middle section.
Third, the mining work found that the top help is not stable, must take support measures, due to blasting or ground pressure to cause damage to the support, should be repaired in time to confirm the safety of the prospective operation.
4. Before the mining, the top plate and the two sets of pumice must be treated first, and the safety must be checked. In the operation, it is found that the warning is to be taken off, and the operation should be stopped, especially if there is a danger of a big roof, the operator should be notified immediately to leave the site.
5. If there is a goaf at the edge of the stope, the edge of the goaf shall be taken first. In case of a stope with broken roof and serious ground pressure, in addition to necessary support, it is necessary to speed up the mining process and minimize the mining. Field exposure time. 
It's quite simple because the stripped wire comes out the other end in a matter of seconds.
Many of these pvc insulated cable peelers can handle wire up to 2 inches thick.
1.If there is an anomaly: when the knife peels the side or the cable is not cut tighten the upper tension bolts which faces the problem;
2. If line core in the cable is deeply cut, please adjust the loosen the upper pressure setting screw, if this is not possible (as you`re already in
Preventive measures against accidents
1. When the multi-layer ore body is layered and recovered, the lower layer of the ore layer must be recovered after the rock at the top of the upper layer collapses and stabilizes.