Hot Dip Galvanizen,Hot Dipped Galvanized Iron Wire,Hot Dip Galvanized,Hot Dip Galvanized Steel TIANJIN YOUFA STEEL CO., LTD , https://www.cnyoufasteel.com
1, high temperature burns, hot and cold impact test chamber in the high temperature test box temperature is high. During the test or at the end of the test, if you need to open the box, be careful when you open the door. Remember to walk in the direction that they are open to avoid burns.
2, low temperature frostbite, cold and heat shock test chamber in the low temperature test when the box temperature is very low. During the test or at the end of the test, special care must be taken to open the door to avoid frostbite.
3, high-temperature burns, hot and cold impact test chamber in the high temperature test box temperature is high. During the test or just after the test, be careful to open the door to avoid burns.
4, electric shock, although the device has a sound protection against electric shock, but still need to pay attention, especially the electrical control system, under working conditions, do not touch the electrical part.
Installation security information:
1. Power supply (1) The high-low temperature test box power supply uses a three-phase five-wire system. The equipment cable is a four-core wire, three phase wires and a neutral wire. Please note the neutral line. Due to the partial load of the equipment and the control system being single-phase, connecting the wrong neutral wire will result in the equipment not working and being damaged.
(2) The grounding wire of the equipment grounding line ensures that the equipment is well grounded and the equipment is safe and reliable. Zero line and ground connection will cause the device to work abnormally.
(3) Due to user premises and other factors, it is necessary to extend the cable. Please ensure that the rated parameters of the extension cord and power supply used meet the power requirements of the product.
2. Site (1) A lot of heat will be generated during the use of this equipment. Please follow the equipment in a well-ventilated place.
(2) Do not use this device near flammable materials or explosive atmospheres.
(3) Do not use in strong magnetic fields and strong vibration environments.
Use security information:
1. Do not connect the power supply of the sample to the power supply of the device, otherwise it will increase the power supply load of the device. Unless the device has a sample power connector.
2. It is strictly prohibited to test flammable, explosive, highly corrosive, and radiated items.
3. Do not carry or overhaul the device while it is powered on or during operation.
If there are any questions or good technical methods, please come to the details.
Equipment using safe thermal shock test equipment
Threatening personal safety information: