SLS laser rapid prototyping is a layering process used for producing fully-functional prototypes. In 3D SLS printing CAD designs are divided into equal digital layers which areprinted and moulded together using lasers.
The SLS Printing Process
Sls Printing Service,Sls 3D Printing,Sintering 3D Printing,Laser Sintering 3D Printing Dongguan ganzoo prototype manufacture co.,ltd , https://www.dgpmsheetmetal.com
For mack truck front and rear twin disc.
Dimension: 350-10*50.8
We have developed over 700 models clutch disc assembly, diameter range from 160mm to 430mm, application covering all kinds of passenger cars, commercial cars, trucks and buses, our main products including Volvo truck, Benz truck, Scania, Man, HOWO and all kinds of Japanese vehicles
We have invested advanced toolings technology from abroad, with CAD and CAM technology, our yearly production ability can be two million sets, and we are considered one important clutch disc manufacturer in China.
For commercial vehicles clutch plate, we had developed all kinds of products for auto type: Volvo truck, Mercedes Benz truck, Scania, Man, Renault, FIAT, Skoda, Iveco, HOWO, and all kinds of Korean and Japanese vehicles like Hyundai, Daewoo, Mitsubishi, Hino, Isuzu. Oil tank trucks, refrigerator truck, transport mixer, towing truck, dumper, self-dumping truck, fire fighting truck, heavy duty trucks, light trucks. The commercial vehicle clutch plate OD. Range from 275mm to 440mm.
According to the Automobile Dry Clutch Disc Assembly Bench Test Technique and Automobile Dry Clutch Disc Assembly Technology Qualification, our clutch disc products were tested and the results showed as follows:
1, Overspeed test: Continuously accelerating clutch disc rotation speed to 8000 RPM at 250 Centi degree, and keep speed for 5 Mins, no crack and damage on the clutch plate.
2, Fatigue test: The clutch plate maximum torque not less than 75% of primary data, after a 3.5X 106 recycle, friction damp torque not less than 60% of primary data;
3, Temperature increase test: Start the clutch plate 10 times, the average temperature less than 10 Centi degree.
4, Dynamic friction torque test: After clutch disc mating with the work surface, when contact surface over 80% at 1500 RPM, force friction disc slip to friction surface to 250Centi degree, the clutch disc unit dynamic friction torque not less than 0.3NM/CM2. The dynamic friction torque at 250Centi degree, not lower than 70% of value at room temperature.
5, Friction facing wearing rate test: After clutch disc assembly mating with the work surface, when contact surface over 80% at 1500 RPM, running the clutch plate 1X104 times, the friction surface wear rate not over 0.65mm, no crack, no bubble and no rivets exposed.
SLS 3D Printing
Clutch Disc for Mack Truck (Mack 4P)
Model NO.: Mack 4P
Working Mode: Power Combining
Working State: No linkage
Voltage: 0
Electromagnetic Clutch: 0
Trademark: Fricwel
Transport Package: Box+Pallet
Specification: GB/T 5764-1998
Origin: China
HS Code: 8708931
Mack 4P Clutch Disc